Multifunction Delay Time Module Switch Control Relay Cycle

SKU: SE72485
250.00 (Incl. Tax)
Features:New upgrades to simplify meeting the users’ needs.LED 3 digits display intelligent control time relay/delay function.The use of opto isolated

Glue Gun 40 Watt

SKU: SE83111
160.00 (Incl. Tax)
Glue Gun 40 Watt No Guarantee No Warranty

MAX7219 LED Dot Matrix 4 In 1 Display with 5P Line Module

SKU: SE39951
350.00 (Incl. Tax)
This is Dot Led Matrix Module incorporating MAX7219 Driver chip. By using this dot LED module in your upcoming project,  you

ST-LINK V2 for STM32

SKU: SE87437
350.00 (Incl. Tax)
ST-LINK V2 Programmer The ST Link V2 Programmer is designed for STM8 and STM32 ans is manufactured with PCB installed inside of aluminum alloy

Atmega16A Microcontroller

SKU: SE84919
235.00 (Incl. Tax)
Atmega16A Microcontroller   The ATmega16A is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing

DC 12V KK-P25/20 8KG Lifting Solenoid Electromagnet

SKU: SE31887
350.00 (Incl. Tax)
This DC 12V KK-P25/20 5KG Lifting Solenoid Electromagnet consists of an iron core and a coil to attract magnetic substances, using

Silver Rod Dia 8mm Length12 Inches

SKU: SE83596
65.00 (Incl. Tax)
Silver Rod Dia 8mm Length12 Inches No Guarantee No Warranty

40×2 Pin Female Berg Strip – Break Away Header Straight

SKU: SE88515
16.00 (Incl. Tax)
40×2 Pin Female Berg Strip – Break Away Header Straight This 40×2 Pin Female Break Away Header Straight has the
ELECTRONICS

KK 2.1.5 Flight Controller Board

SKU: SE33942
4,500.00 (Incl. Tax)
The KK2.1 is next big evolution of the first generation KK flight control boards. The KK2.1 was engineered from the

1400KV BLDC Brushless Motor

SKU: SE75998
410.00 (Incl. Tax)
A2212 is a brushless outrunner dc motor specifically made to power Quadcopters and Multirotors. It is a 1400kV motor. It

Infra Red IR Smart car Obstacle Avoidance Sensor

SKU: SE85351
40.00 (Incl. Tax)
IR Sensor module has great adaptive capability of the ambient light, having a pair of infrared transmitter and the receiver

3D Printer RAMPS 1.4 Control Board

SKU: SE45517
280.00 (Incl. Tax)
Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in

12 Volt 1.5 Amp. Battery

SKU: SE97521
236.00 (Incl. Tax)
12 Volt 1.5 Amp. Battery No Guarantee No Warranty

12 Volt 2 Amp. Battery

SKU: SE39157
300.00 (Incl. Tax)
12 Volt 2 Amp. Battery No Guarantee No Warranty