Performance Wonderful Arduino Uno DIP Supported By Arduino IDE ₹ 500 BUY NOW Performance Wonderful Arduino Uno SMD Supported With Arduino IDE ₹350 BUY NOW Higher level performance ESP32 Wifi Module Built in Wifi & Bluetooth Module ₹440 BUY NOW

LDR – Light Dependent Resistor – Large

SKU: SE94734
₹30.00 (Incl. Tax)

A photoresistor or light dependent resistor is a component that is sensitive to light. When light falls upon it then

1 Channel 12V Relay Module With Screw Terminal

SKU: SE25278
₹50.00 (Incl. Tax)

1-Channel 12V Relay Module is a 12V 1-channel relay interface board with screw terminal, it can be controlled directly by

CD4040 Ripple-Carry Binary Counter/Divider IC

SKU: SE86727
₹25.00 (Incl. Tax)

CD4040 Ripple-Carry Binary Counter/Divider IC No Guarantee No Warranty

CD 4016 IC

SKU: SE26585
₹25.00 (Incl. Tax)

CD 4016 IC No Guarantee No Warranty

Motor Controller 24V for MY1016 250W

SKU: SE62719
₹700.00 (Incl. Tax)

This Motor Controller 24V for MY1016 250W includes attachments for the motor, accelerator, brake, battery, battery charging, brake light, power lock.

Sold out

DJI Naza M Lite Multi-Rotor Flight Controller with LED, PMU, GPS

SKU: SE31342
₹6,500.00 (Incl. Tax)

Introduction This is an all-in-one DJI flight controller. For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the

MPU-6050 3-Axis Accelerometer and Gyro Sensor

SKU: SE86241
₹150.00 (Incl. Tax)

The MPU-6050 3-Axis Accelerometer and Gyro Sensor module use MPU-6050 which is a little piece of motion processing tech!!! There

ELECTRONICS

KK 2.1.5 Flight Controller Board

SKU: SE33942
₹4,250.00 (Incl. Tax)

The KK2.1 is next big evolution of the first generation KK flight control boards. The KK2.1 was engineered from the

Sold out

1400KV BLDC Brushless Motor

SKU: SE75998
₹400.00 (Incl. Tax)

A2212 is a brushless outrunner dc motor specifically made to power Quadcopters and Multirotors. It is a 1400kV motor. It

Infra Red IR Smart car Obstacle Avoidance Sensor

SKU: SE85351
₹40.00 (Incl. Tax)

IR Sensor module has great adaptive capability of the ambient light, having a pair of infrared transmitter and the receiver

Sold out

3D Printer RAMPS 1.4 Control Board

SKU: SE45517
₹280.00 (Incl. Tax)

Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in

Sold out

12 Volt 1.5 Amp. Battery

SKU: SE97521
₹236.00 (Incl. Tax)

12 Volt 1.5 Amp. Battery No Guarantee No Warranty

Sold out

12 Volt 2 Amp. Battery

SKU: SE39157
₹300.00 (Incl. Tax)

12 Volt 2 Amp. Battery No Guarantee No Warranty