USB Type-A Female Connector

SKU: SE78118
10.00 (Incl. Tax)
USB Type ‘A’ Female SMD connector. For use with any PCB that will be used with a Type A to

RS-37 100 RPM High Torque Side Shaft DC Geared Motor

SKU: SE79361
800.00 (Incl. Tax)
RS-37 Gear motor is widely used for Industrial Applications. Carries torque greater as compared to Johnson Geared Motors and consumes

2 Pin RMC Relimate Connector Male Female

SKU: SE85881
5.00 (Incl. Tax)
RMC Relimate connector is a general-purpose connector with 2 pins connector at one end with a 25cm cable. It has

Shaft Dia-6mm with Length – 3 inch Material-MS

SKU: SE77747
25.00 (Incl. Tax)
Description This is 6mm Shaft/Rod with the length of- 3inch, it has 2 holes at both ends. Technical Specification: Material

Trapezoidal Lead Screws Pitch 8mm Lenth 400mm + Copper Nut

SKU: SE32423
340.00 (Incl. Tax)
The 400mm Trapezoidal 4 Start Lead Screw 8mm Thread 2mm Pitch Lead Screw with Copper Nut used for general machine

400KV Step Up Power Module

SKU: SE11654
200.00 (Incl. Tax)
400KV Step Up Power Module This is a high voltage step-up power supply module, which is commonly used in electronics

220uF 25V Electrolytic Capacitor – 3 Pieces Pack

SKU: SE48319
10.00 (Incl. Tax)
220uF 25V Electrolytic Capacitor is a high quality electrolytic capacitor which offers long life and high reliability. Electrolytic Capacitors are

Uno R3 CH340G ATmega328p Development Board Compatible with Arduino

SKU: SE56268
330.00 (Incl. Tax)
The Uno R3 CH340G ATmega328p Development Board is the low-cost version of the popular Uno R3 Arduino. It is assembled
ELECTRONICS

KK 2.1.5 Flight Controller Board

SKU: SE33942
4,500.00 (Incl. Tax)
The KK2.1 is next big evolution of the first generation KK flight control boards. The KK2.1 was engineered from the

1400KV BLDC Brushless Motor

SKU: SE75998
410.00 (Incl. Tax)
A2212 is a brushless outrunner dc motor specifically made to power Quadcopters and Multirotors. It is a 1400kV motor. It

Infra Red IR Smart car Obstacle Avoidance Sensor

SKU: SE85351
40.00 (Incl. Tax)
IR Sensor module has great adaptive capability of the ambient light, having a pair of infrared transmitter and the receiver

3D Printer RAMPS 1.4 Control Board

SKU: SE45517
280.00 (Incl. Tax)
Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in

12 Volt 1.5 Amp. Battery

SKU: SE97521
236.00 (Incl. Tax)
12 Volt 1.5 Amp. Battery No Guarantee No Warranty

12 Volt 2 Amp. Battery

SKU: SE39157
300.00 (Incl. Tax)
12 Volt 2 Amp. Battery No Guarantee No Warranty