RFID – 1 KiloByte Slim Cards

SKU: SE73192
20.00 (Incl. Tax)
This is a blank 13.56MHz RFID/NFC card – often used for train/bus passes but also found in other systems where

Stepper Motor Driver TB6600 Subdivision 4.0A 42V

SKU: SE48328
550.00 (Incl. Tax)
TB6600 stepper motor driver provides maximum 4.0A output current. TB6600 comes with output sort-circuit protection, Low-Pressure shut-off, Overheating parking and

BMP280 Barometric Pressure and Altitude Sensor I2C SPI Module

SKU: SE44332
60.00 (Incl. Tax)
BMP280 Barometric Pressure and Altitude Sensor I2C/SPI Module is a cheapest and tiny Atmospheric Sensor Breakout to measure barometric pressure,

ESP32 Development Board WiFi+Bluetooth 38 Pin

SKU: SE81719
460.00 (Incl. Tax)
ESP32 Development board is based on the ESP WROOM32 WIFI + BLE Module.It’s a low-footprint, minimal system development board powered

10uF 50V Electrolytic Capacitor – 3 Pieces Pack

SKU: SE61252
9.00 (Incl. Tax)
10uF 50V Electrolytic Capacitor is a high quality electrolytic capacitor which offers long life and high reliability. Electrolytic Capacitors are

Male & Female Gold Plated Bullet Connector Pair 3.5 mm

SKU: SE95664
30.00 (Incl. Tax)
This is a pack of 1 female and 1 male 3.5mm bullet connectors, useful for connecting small ESCs to motors

1M POTENTIOMETER POT

SKU: SE16365
15.00 (Incl. Tax)
Pots are variable resistors. They can be use for various purpouses. Practically it can vary with in  little range respect

ATTiny85 USB Development Board

SKU: SE72867
180.00 (Incl. Tax)
The ATtiny85 based mini development board is similar to the Arduino, but cheaper and smaller (of course a bit less
ELECTRONICS

KK 2.1.5 Flight Controller Board

SKU: SE33942
4,500.00 (Incl. Tax)
The KK2.1 is next big evolution of the first generation KK flight control boards. The KK2.1 was engineered from the

1400KV BLDC Brushless Motor

SKU: SE75998
410.00 (Incl. Tax)
A2212 is a brushless outrunner dc motor specifically made to power Quadcopters and Multirotors. It is a 1400kV motor. It

Infra Red IR Smart car Obstacle Avoidance Sensor

SKU: SE85351
40.00 (Incl. Tax)
IR Sensor module has great adaptive capability of the ambient light, having a pair of infrared transmitter and the receiver

3D Printer RAMPS 1.4 Control Board

SKU: SE45517
280.00 (Incl. Tax)
Fully assembled & tested, no soldering required It is designed to fit the entire electronics needed for a RepRap in

12 Volt 1.5 Amp. Battery

SKU: SE97521
236.00 (Incl. Tax)
12 Volt 1.5 Amp. Battery No Guarantee No Warranty

12 Volt 2 Amp. Battery

SKU: SE39157
300.00 (Incl. Tax)
12 Volt 2 Amp. Battery No Guarantee No Warranty